Maintaining Alarm Relay Wire - Juniper EX9214 Hardware Manual

Hide thumbs Also See for EX9214:

Table of Contents

CAUTION: Do not let fiber-optic cable hang free from the connector. Do not allow

fastened loops of cable to dangle, which stresses the cable at the fastening point.

CAUTION: Avoid bending fiber-optic cable beyond its minimum bend radius. An arc

smaller than a few inches in diameter can damage the cable and cause problems that

are difficult to diagnose.

Figure 87: Install a Transceiver

Ejector lever

Maintaining Alarm Relay Wire

IN THIS SECTION

Disconnecting the Alarm Relay Wires from the Craft Interface in an EX9200 Switch | 272

Connecting the Alarm Relay Wires to the Craft Interface in an EX9200 Switch | 272