Table of Contents
Advertisement
Chapter 12: Emulator/Analyzer Interface Commands
trace
trace
This command allows you to trace program execution using the emulation analyzer.
Note that the options shown can be executed once for each trace command. Refer
to the TRIGGER and QUALIFIER diagrams for details on setting up a trace.
You can perform analysis tasks either by starting a program run and then specifying
the trace parameters, or by specifying the trace parameters first and then initiating
the program run. Once a trace begins, the analyzer monitors the system busses of
the emulation processor to detect the states specified in the trace command.
When the trace specification is satisfied and trace memory is filled, a message will
appear on the status line indicating the trace is complete. You can then use display
trace to display the contents of the trace memory. If a previous trace list is on
screen, the current trace automatically updates the display. If the trace memory
423
Advertisement
Table of Contents
