Table of Contents
Advertisement
Parasitic circuit parameters in the emulator/target interconnect may cause problems
when the target system uses a high frequency crystal. The frequency limit is very
much dependent on the target system. Under favorable conditions, operation at full
speed may be possible with the jumper.
If you can use the provided jumper, go on to Step 4; otherwise, perform the
following steps.
1 Remove plastic rivets that secure the plastic cover on the top of the emulator probe, and remove the
cover.
Chapter 2: Plugging into a Target System
Step 3. Set up the probe for the clock source
51
Advertisement
Table of Contents
