Table of Contents
Advertisement
ROM. (You can, however, copy target ROM to emulation memory by storing the
contents of target ROM to an absolute file, re-mapping the range as emulation
RAM, and loading the absolute file.)
This section shows you how to:
•
Display the breakpoints list.
•
Enable/disable breakpoints.
•
Set a permanent breakpoint.
•
Set a temporary breakpoint.
•
Set all breakpoints.
•
Deactivate a breakpoint.
•
Re-activate a breakpoint.
•
Clear a breakpoint.
•
Clear all breakpoints.
To display the breakpoints list
• Choose Display→Breakpoints or Breakpoints→Display.
• Using the command line, enter the display software_breakpoints command.
The breakpoints display shows the address and status of each breakpoint currently
defined. If symbolic addresses are turned on (when setting the display modes), the
symbolic label associated with a breakpoint is also displayed. Also, the breakpoints
display shows whether the breakpoint feature is enabled or disabled.
Chapter 6: Using the Emulator
Using Software Breakpoints
151
Advertisement
Table of Contents
