Installation overview
The following steps in the hardware installation process are described in this
section:
The steps in the installation process are:
1
Connect the HP 64767 emulator probe to the HP 64748C emulator control card.
2
Install cards into the HP 64700 card cage.
3
Connect the emulator probe to the demo target system.
4
Apply power to the HP 64700.
Your emulation and analysis system may already be assembled (depending on how
parts of the system were ordered).
Antistatic precautions
Integrated-circuit boards contain electrical components that are easily damaged by
small amounts of static electricity. To avoid damage to the emulator cards, follow
these guidelines:
•
If possible, work at a static-free workstation.
•
Handle the boards only by the edges; do not touch components or traces.
•
Use a grounding wrist strap that is connected to the HP 64700's chassis.
Chapter 16: Installation
Installing Hardware
499