HP 64767 User Manual page 468

Chapter 13: Error Messages
Terminal Interface Messages
680 Stepping failed
Cause: Stepping has failed for some reason.
Action: Usually, this error message will occur with other error messages. Refer to
the descriptions of the accompanying error messages to find out more about why
stepping failed.
684
Failed to disable step mode
Cause: System failure.
Action: Run performance verification (Terminal Interface pv command).
686
Stepping aborted; number steps completed: %d
Cause: This message is displayed if a break was received during a step command
with a step count greater than zero. The break could have been due to any of the
break conditions or a <CTRL>c break. The number of steps completed is displayed.
688 Step display failed
Cause: System failure or target condition.
Action: Check memory mapping and configuration questions.
689 Break due to cause other than step
Cause: An activity other than a step command caused the emulator to break. This
could include any of the break conditions or a <CTRL>c break.
692
Trace error during CMB execute
Cause: System failure.
Action: Run performance verification (Terminal Interface pv command).
693
CMB execute; run started
Cause: This status message is displayed when you are making coordinated
measurements. The CMB /EXECUTE pulse has been received; the emulation
processor started running at the address specified by the specify run command.
Action: None; information only.
468