Sequencing - HP 64767 User Manual

Chapter 12: Emulator/Analyzer Interface Commands

SEQUENCING

SEQUENCING
Lets you specify complex branching activity that must be satisfied to trigger the
analyzer.
Sequencing provides you with parameters for the trace command that let you
define branching conditions for the analyzer trigger.
You are limited to a total of seven sequence terms, including the trigger, if no
windowing specification is given. If windowing is selected, you are limited to a
total of four sequence terms.
The analyzer default is no sequencing terms. If you select the sequencer using the
find_sequence parameter, you must specify at least one qualifying sequence term.
The parameters are as follows:
find_sequence
Specifies that you want to use the analysis sequencer. You must enter at least one
qualifier.
QUALIFIER
Specifies the address, data, status, or executed address value or value range that will
satisfy this sequence term if looking for a sequence (find_sequence), or will restart
at the beginning of the sequence (restart). See the QUALIFIER syntax pages for
further information.
398