Table of Contents
Advertisement
107
Monitor failure; bus error
Cause: The monitor is unable to run because the processor has encountered a bus
fault.
Action: Determine why the bus error was activated.
80186/8/XL/EA/EB Emulator Messages
The following error messages are unique to the HP 64767 emulator.
140
User code load module too big
Cause: This error occurs when the size of the user program absolute code is greater
than 1 Mbyte.
Action: Modify the user program so that the absolute code generated takes up less
than 1 Mbyte.
141
Foreground monitor load module too big
Cause: This error occurs when the size of the user foreground monitor program
absolute code is greater than 4 Kbytes.
Action: Modify the user foreground monitor program so that the absolute code
generated takes up less than 4 Kbytes.
153
Second term physically smaller than first term
Cause: This error occurs when specifying an address range (<addr> thru <addr>)
and the first address is higher than the second address.
Action: Make sure the first address is lower than the second address when
specifying address ranges.
154
Range terms must be same type (physical or logical)
Cause: This error occurs when specifying an address range (<addr> thru <addr>)
and one address is specified as a logical address (segment:offset) while the other
address is specified as a physical address.
Action: Make sure that both addresses in the range are either logical or physical
addresses.
Chapter 13: Error Messages
Terminal Interface Messages
457
Advertisement
Table of Contents
