HP 64767 User Manual page 469

694
Run failed during CMB execute
Cause: System failure or target condition.
Action: Run performance verification (Terminal Interface pv command), and
check target system.
700 Target memory access failed
Cause: This message is displayed if the emulator was unable to perform the
requested operation on memory mapped to the target system.
Action: In most cases, the problem results from the emulator's inability to break to
the monitor to perform the operation. See message 608.
702
Emulation memory access failed
Cause: System failure.
Action: Run performance verification (Terminal Interface pv command).
707
Request access to guarded memory: %s
Cause: The address or address range specified in the command included addresses
within a range mapped as guarded memory. When the emulator attempts to access
these during command processing, the above message is printed, along with the
specific address or addresses accessed.
Action: Re-enter the command and specify only addresses or address ranges within
emulation or target RAM or ROM. Or, you can remap memory so that the desired
addresses are no longer mapped as guarded.
710
Memory range overflow
Cause: Accessing a word or short word, for example display memory 0fffffh
blocked word will cause a rounding error that overflows physical memory.
Action: Reduce memory display request.
725 Unable to load new memory map; old map reloaded
Cause: There is not enough emulation memory left for this request.
Action: Reduce the amount of emulation memory requested.
Chapter 13: Error Messages
Terminal Interface Messages
469