HP 64767 User Manual page 460

Chapter 13: Error Messages
Terminal Interface Messages
communications parameters are set correctly on the host and on the HP 64700, then
retry the operation.
411 Severe error detected, file transfer failed
Cause: An unrecoverable error occurred during a transfer operation.
Action: Retry the transfer. If it fails again, make sure that the data
communications parameters are set correctly on the host and on the HP 64700.
Also make sure that you are using the correct command options, both on the
HP 64700 and on the host.
412
Retry limit exceeded, transfer failed
Cause: The limit for repeated attempts to send a record during a transfer operation
was exceeded, therefore the transfer was aborted.
Action: Retry the transfer. Make sure you are using the correct command options
for both the host and the HP 64700. The data communications parameters need to
be set correctly for both devices. Also, if you are in a remote location from the
host, it is possible that line noise may cause the failure.
413
Transfer failed to start
Cause: Communication link or transfer protocol incorrect.
Action: Check link and transfer options.
415
Timeout, receiver failed to respond
Cause: Communication link or transfer protocol incorrect.
Action: Check link and transfer options.
600 Adjust PC failed during break
Cause: System failure or target condition.
Action: Run performance verification (Terminal Interface pv command), and
check target system.
602
Break failed
Cause: The break command was unable to break the emulator to the monitor.
460