HP 64767 User Manual page 467

665
Enable breakpoint failed: %s
Cause: System failure or target condition.
Action: Check memory mapping and configuration questions.
666
Disable breakpoint failed: %s
Cause: System failure or target condition.
Action: Check memory mapping and configuration questions.
667
Breakpoint code already exists: %s
Cause: You attempted to insert a breakpoint; however, there was already a
software breakpoint instruction at that location which was not already in the
breakpoint table.
Action: Your program code is apparently using the same instructions as used by
the software breakpoints feature. Remove the breakpoint instructions from your
program code and use the modify software_breakpoints set command to insert
them.
668
Breakpoint not added: %s
Cause: You tried to insert a breakpoint in a memory location which was not
mapped or was mapped as guarded memory.
Action: Insert breakpoints only within memory ranges mapped to emulation or
target RAM or ROM.
669 Breakpoint remove aborted
Cause: Occurs when <CTRL>c is entered when clearing a software breakpoint.
670
Breakpoint enable aborted
Cause: Occurs when <CTRL>c is entered when setting software breakpoints.
671
Breakpoint disable aborted
Cause: Occurs when <CTRL>c is entered when disabling software breakpoints.
Chapter 13: Error Messages
Terminal Interface Messages
467