Table of Contents
Advertisement
Chapter 16: Installation
Verifying the Installation
A typical entry for a 80186/8/XL/EA/EB emulator connected to an RS-422 port
would appear as follows:
#-------------------------------------------------------------------------------
#
|
# Channel| Logical
#
Type
|
Name
#
|
#-------------------------------------------------------------------------------
serial:
em8018x
Step 2. Start the interface with the emul700
command
1 Apply power to the emulator you wish to access after making sure the emulator is
connected to the LAN or to your host system.
On the HP 64700 Series Emulator, the power switch is located on the front panel
near the bottom edge. Push the switch in to turn power on to the emulator.
2 Wait a few seconds to allow the emulator to complete its startup initialization.
3 Choose a terminal window from which to start the Graphical User Interface.
4 Start the Graphical User Interface by entering emul700 command and giving the
logical name of the emulator as an argument to the command, as in
$HP64000/bin/emul700 <logical_name> &
or
emul700 <logical name> &
if $HP64000/bin is in your path.
If you are running the X server, if the Graphical User Interface is installed, and if
your DISPLAY environment variable is set, the emul700 command will start the
534
|
|
|
| Processor | Host |
|
Type
| Name |
|
|
|
i186xl
myhost /dev/emcom23 OFF
|Xpar|Parity|Flow|Stop|Char
Physical
|Mode|
Device
|
|
|OFF | NONE |RTS | 2
NONE
|
|Bits|Size
|XON |
|
| 8
RTS
2
8
Advertisement
Table of Contents
