HP 64767 User Manual page 462

Chapter 13: Error Messages
Terminal Interface Messages
610 Unable to run
Cause: System failure or target condition.
Action: Run performance verification (Terminal Interface pv command), and
check target system.
611
Break caused by CMB not ready
Cause: This status message is printed during coordinated measurements if the
CMB READY line goes false. The emulator breaks to the monitor. When CMB
READY is false, it indicates that one or more of the instruments participating in the
measurement is running in the monitor.
Action: None, information only.
612 Write to ROM break
Cause: This status message will be printed if you have enabled breaks on writes to
ROM and the emulation processor attempted a write to a memory location mapped
as ROM.
Action: None (except troubleshooting your program).
613
Analyzer Break
Cause: Status message.
614
Guarded memory access break
Cause: This message is displayed if the emulation processor attempts to read or
write memory mapped as guarded.
Action: Troubleshoot your program; or, you may have mapped memory incorrectly.
615
Software breakpoint: %s
Cause: This status message will be displayed if a software breakpoint is
encountered during a program run. The emulator is broken to the monitor. The
string %s indicates the address where the breakpoint was encountered.
462