Table of Contents
Advertisement
Plugging the Emulator into a Target
System
This chapter describes the steps you must perform when connecting the emulator to
a target system:
1
2
3
4
CAUTION
Possible Damage to the Emulator Probe. The emulation probe contains devices
that are susceptible to damage by static discharge. Therefore, precautionary
measures should be taken before handling the microprocessor connector attached to
the end of the probe cable to avoid damaging the internal components of the probe
by static electricity.
We STRONGLY suggest using a ground strap when handling the emulator
probe. A ground strap is provided with the emulator.
48
Turn OFF power.
If the emulator is currently connected to the demo target system or a different
target system, unplug the emulator probe.
Plug the emulator probe into the target system.
Turn ON power (first the HP 64700, then the target system).
Advertisement
Table of Contents
