Table of Contents
Advertisement
Chapter 13: Error Messages
Terminal Interface Messages
650
Unable to configure break on write to ROM
Cause: The emulator controller is unable to configure for breaks on writes to
ROM, possibly because the emulator was left in an unknown state or because of a
hardware failure.
Action: Initialize the emulator or cycle power. Then reenter the command. If the
same failure occurs, call your HP sales and service office.
651
Unable to configure break on software breakpoints
Cause: The emulator controller cannot enable breakpoints, possibly because the
emulator is in an unknown state or because of a hardware failure.
Action: Initialize the emulator or cycle power, then re-enter the command. If the
same failure occurs, call your HP sales and service office.
653
Break condition configuration aborted
Cause: Occurs when <CTRL>c is entered during the configuration of break
conditions.
661
Software breakpoint break condition is disabled
Cause: You have attempted to set or clear a software breakpoint when software
breakpoints are disabled.
Action: You must enable software breakpoints before you can set them.
663
Specified breakpoint not in list: %s
Cause: You tried to clear a software breakpoint that was not previously set. The
string %s prints the address of the breakpoint you attempted to clear.
Action: You must first set a software breakpoint before it can be cleared.
664
Breakpoint list full; not added: %s
Cause: The software breakpoint table is already reached the maximum of 32
breakpoints. The breakpoint you just requested, with address %s, was not inserted.
Action: Clear breakpoints that are no longer in use. Then, set the new breakpoint.
466
Advertisement
Table of Contents
