Ricoh 4800WD Operating Instructions Manual page 71

❒ Depending on paper type, operating conditions (low temperature and hu-
midity), and paper feeding settings (multiple copies on paper of 542 mm,
22" width or less), toner fusing conditions vary. To improve toner fusing,
change the thickness level to 3→2→1.
❒ When using thin, soft, or limp paper, toner fusing may appear wrinkled or
the image may be blurred. If this happens, change the thickness level to
3→4→5.
❒ When level 1 or 2 are selected for translucent paper , and you change the
paper type from plain or film to translucent, it may take longer for the ma-
chine to get ready for copying (up to two minutes).
❒ When level 1 or 2 are selected for translucent paper, and you make copies
on paper of size A1(D) or above continuously, the interval between each
copying may take longer. Even if you make copy on one sheet only, it may
takes 1 minute until the next copy job starts.
❖ ❖ ❖ ❖ Paper Thickness: Paper Bypass
You can specify the thickness of paper placed in the paper bypass. If the im-
age on copies is scratched, or the paper wrinkles when using translucent pa-
per, you can change the setting to get better copies.
Note
❒ Default: 2 (Plain Paper, Translucent paper, and Recycled Paper), 3 (Film)
❒ The paper thickness can be set from 1 (Thicker) to 5 (Thinner). See p.58 "Pa-
per Thickness: Paper Tray". The results for hemmed paper cannot be guar-
anteed.
❖ ❖ ❖ ❖ Paper Size Detect Method
You can specify Engineering or Architecture as the default paper size detect
method.
Note
❒ Default: Architecture
❖ ❖ ❖ ❖ Paper Volume
You can specify how the paper volume should be displayed when a paper roll
is loaded in the paper roll tray. You can specify this setting for each paper roll
tray. When a new roll is loaded, the display is "New (Full)".
Note
❒ Default: New (Full)
Settings You Can Change with User Tools
4
59