Ricoh 4800WD Operating Instructions Manual page 329

B B B B
Press [Change] for items you want
to use as search conditions from
the following: [Name], [E-mail Ad-
dress], [Company Name], and [De-
partment Name].
C C C C
Enter the attribute you want to
use when searching for e-mail ad-
dresses, and then press [OK].
Note
❒ The attribute value may change
depending on the server envi-
ronment. Check the attribute
value complies with your server
environment before setting it.
❒ You can leave items blank, but
you cannot leave attributes
blank when searching for e-mail
addresses from the LDAP serv-
er Address Book.
To set search options
To search the LDAP server data using
a keyword other than prepared key-
words such as Name, E-mail Address,
Company Name, and Department
Name, specify the attribute for the key-
word registered in your LDAP server,
and the name to be displayed on the
control panel during the search. For ex-
ample, to search e-mail addresses by
employee number, enter "employee
No." in the Attribute field, and "Em-
ployee No." in the key display field.
A A A A
Press [T T T T Next] three times.
B B B B
Press [Change] under [Attribute].
C C C C
Enter the attribute you want to
use when searching for e-mail ad-
dresses, and then press [OK].
Note
❒ The attribute value may change
depending on the server envi-
ronment. Check the attribute
complies with your server envi-
ronment before setting it.
D D D D
Press [Change] under [Key Display].
E E E E
Enter the key display, and then
press [OK].
The registered "key display" ap-
pears as a keyword for searching
LDAP.
• Without key display registration
• With key display registration
Note
❒ The key does not appear on the
search screen unless both "At-
tribute" and "Key Display" are
registered. Make sure you regis-
ter both to use the optional
search.
LDAP Server Settings
37
2