Ricoh 4800WD Operating Instructions Manual page 586

Troubleshooting
Message
Exceeded max. number of alphanumeric
characters.
Exceeded max. number of alphanumeric
characters for the path.
Exceeded max. number of files which
can be sent at the same time. Reduce
the number of the selected files.
Exceeded max. number of files which
can be used in Document Server at the
same time.
Exceeded max. number of pages per
file. Do you want to store the scanned
pages as 1 file?
Exceeded max. number of standby files.
Try again after the current file is
sent.
8
Exceeded max. page capacity per file.
Press [Send] to send the scanned data,
or press [Cancel] to delete.
Exceeded time limit for LDAP server
search. Check the server status.
LDAP server authentication has failed.
Check the settings.
Load paper of the following sizes. Re-
quired: A3S B4S A4S A4R
88
Causes and solutions
Make sure the maximum number of
characters which can be entered, and
then enter it again. See p.112 "Speci-
fications for Transmis-
sion/Store/Delivery Functions".
The maximum number of characters
which can be entered for the path is
128. Check the number of character
you entered, and then enter the path
again. See p.113 "Scan to Folder".
The number of files exceeded the
maximum number possible. Reduce
the number of files and send them
again.
Check the files stored by the other
functions, and then delete unneeded
files. See "Document Server", General
Settings Guide.
Specify whether to use the data or
not. Scan the pages that were not
scanned and store them as a new file.
See p.43 "Storing Files".
There are 100 files waiting in the
sending queue for e-mail, Scan to
Folder, or delivery functions. Wait
until files have been sent.
Because the number of pages has
reached the maximum number that
can be sent, the data up to this point
is sent. Scan the remaining pages af-
ter transmission.
A network error has occurred and
connection has failed. Try the opera-
tion once more. If the message is still
shown, the network may be crowd-
ed. Check the information of System
Settings. See "User Tools (System
Settings)", General Settings Guide.
Make settings correctly for the user
name and the password for LDAP
server authentication.
Load paper of the sizes listed in the
message.