HP 8163A Programming Manual page 85

command: :SENSe[n][:CHANnel[n]]:FUNCtion:THReshold?
syntax: :SENSe[n][:CHANnel[n]]:FUNCtion:THReshold?
description: Returns the start mode and the threshold value.
parameters: none
response: ABOV:
BEL:
IMM:
Threshold Value:
example:
sens1:func:thr?
affects: All power meter modules
command: :SENSe[n]:[CHANnel[n]]:POWer:ATIME
syntax: :SENSe[n]:[CHANnel[n]]:POWer:ATIME<wsp><averaging time>
[NS|US|MS|S]
description: Sets the averaging time for the module.
parameters: The averaging time as a float value in seconds.
If you specify no units in your command, seconds are used as the default.
response: none
example:
sens1:pow:atime 1s
affects: All power meter modules
command: :SENSe[n]:[CHANnel[n]]:POWer:ATIME?
syntax: :SENSe[n]:[CHANnel[n]]:POWer:ATIME?
description: Returns the averaging time for the module.
parameters: none
response: The averaging time as a float value in seconds.
example:
sens1:pow:atime?
affects: All power meter modules
Introduction to Programming
Measurement Functions – The SENSe Subsystem
→
IMM,+2.00000000E-008
→
+1.00000000E+000<END>
85
Function starts when power is above the
threshold value.
Function starts when power is below the
threshold value.
Function starts immediately.
A float value in Watts or dBm.
<END>