HP 8163A Programming Manual page 41

Command
[:SOURce[n]][:CHANnel[n]:]WAVelength
[:CW|:FIXed]/?
:FREQuency/?
:REFerence?
[:SOURce[n]][:CHANnel[n]:]WAVelength:CORRection
:ARA
:ZERO
[:SOURce[n]][:CHANnel[n]:]WAVelength:REFerence
:DISPlay
[:SOURce[n]][:CHANnel[n]:]WAVelength:SWEep
:CYCLes/?
:DWELl/?
:MODE/?
:PMAX?
:REPeat/?
:SPEed/?
:STARt/?
:STOP/?
[:STATe]/?
[:SOURce[n]][:CHANnel[n]:]WAVelength:SWEep:STEP
:NEXT
Table 2-1
Specific Commands
Specific Command Summary
Description
Sets or returns the absolute wavelength of a
source.
Sets the frequency difference used to calculate a
relative wavelength for a source.
Returns the reference wavelength of a source.
Realigns the laser cavity.
Exexutes a wavelength zero.
Sets the reference wavelength of a source to the
value of the output wavelength.
Sets or returns the number of cycles.
Sets or returns the dwell time.
Sets or returns the sweep mode.
Returns the highest permissible power for a
wavelength sweep.
Sets or returns the repeat mode.
Sets or returns the speed for continuous sweeping.
Sets or returns the start point of the sweep.
Sets or returns the end point of the sweep.
Stops, starts, pauses or continues a wavelength
sweep or returns the the state of a sweep.
Performs the next sweep step.
Specific Command Summary, continued
41
Page
110
112
113
111
111
113
113
114
115
116
117
117
118
119
119
120