HP 8163A Programming Manual page 39

Command
:PARameter:STABility/?
:RESult?
:STATe/?
:THReshold/?
:SENSe[n][:CHANnel[n]]:POWer
:ATIME/?
:RANGe[:UPPer]/?
:RANGe:AUTO/?
:REFerence/?
UNIT/?
:WAVelength/?
:SENSe[n][:CHANnel[n]]:POWer:REFerence
:DISPlay
:STATe/?
:STATe:RATio/?
:SLOT[n][:HEAD[n]]
:EMPTy?
:IDN?
Table 2-1
Specific Commands
Specific Command Summary
Description
Sets or returns the total time, delay time and the
averaging time, t
Returns the data array of the last function.
Enables/disables the function mode or returns
whether the function mode is enabled.
Sets or returns the threshold value and the start
mode.
Sets or returns the average time of a sensor.
Sets or returns the most positive signal entry
expected for a sensor.
Sets or returns the range of a sensor to produce the
most dynamic range without overloading.
Sets or returns the reference level of a sensor.
Sets or returns the units used for absolute readings
on a sensor.
Sets or returns the wavelength for a sensor.
Sets the reference level for a sensor from the input
power level.
Sets or returns whether sensor results are in
relative or absolute units.
Sets or returns whether sensor results are
displayed relative to a channel or to an absolute
reference.
Returns whether the module slot is empty.
Returns information about the module.
Specific Command Summary, continued
39
, for stability.
avg
Page
82
83
83
84
85
86
87
88
91
92
89
89
90
72
72