HP 8163A Programming Manual page 114

command: [:SOURce[n]][:CHANnel[n]]:WAVelength:SWEep:CYCLes?
syntax: [:SOURce[n]][:CHANnel[n]]:WAVelength:SWEep:CYCLes?
[<wsp>MIN|MAX|DEF]
description: Returns the number of cycles.
parameters: none
Also allowed are:
response: The number of cycles as an integer value.
example:
wav:swe:cycl?
affects: All Tunable Laser modules
command: [:SOURce[n]][:CHANnel[n]]:WAVelength:SWEep:DWELl
syntax: [:SOURce[n]][:CHANnel[n]]:WAVelength:SWEep:DWELl<wsp>
<value>|MIN|MAX|DEF[NS|US|MS|S]
description: Sets the dwell time.
parameters: The dwell time as a float value.
If you specify no units in your command, seconds are used as the default.
Also allowed are:
response: none
example:
wav:swe:dwel 500ms
affects: All Tunable Laser modules
Introduction to Programming
Signal Generation – The SOURce Subsystem
MIN: minimum programmable value
MAX: maximum programmable value
DEF: This is not the preset (*RST) default value but
is half the sum of, the minimum programmable
value and the maximum programmable value
→
+3<END>
MIN: minimum programmable value
MAX: maximum programmable value
DEF: This is not the preset (*RST) default value but
is half the sum of, the minimum programmable
value and the maximum programmable value
114