Changed Parameter Syntax And Semantics; Table B-3 Obsolete Commands; Table B-4 Commands With Different Parameters Or Syntax - HP 8163A Programming Manual

Old Command
DISPlay:STATe/?
PROGram command tree
Return Loss Module
Commands
Table B-3
Command
SOUR:AM:FREQ/?
DISP:BRIG
SENS:CORR:COLL:ZERO?
Table B-4
HP-IB Command Compatibility List
Compatibility Issues
New Command
DISPlay:ENABle/?
SENSe:FUNCtion command tree.
Some commands from the PROGram command tree
have not been replaced.
The HP 8153A application interface on the HP-IB is not
supported.
Stability/Logging and Min/Max are available via a new
interface.
The commands for the return loss modules will be
completely different than those for the HP 8153A.
Obsolete Commands

Changed Parameter Syntax and Semantics

Table B-4 details commands whose parameter syntax or semantics
have changed.
Change
This command does not accept the value CW, instead
use SOUR:AM:STAT ON|OFF to switch from and to
CW mode.
The commands accepts floating point values.
This command now supports integers between 1 and
100, instead of float values between 1 and 0.
This command returns the last zero state, instead of the
last remote zero state.
Commands with Different Parameters or Syntax
191
Affects
8153
8153
8153
Affects
8153
8153
8153