HP 8163A Programming Manual page 118

command: [:SOURce[n]][:CHANnel[n]]:WAVelength:SWEep:SPEed?
syntax: [:SOURce[n]][:CHANnel[n]]:WAVelength:SWEep:SPEed?
description: Returns the speed for continuous sweeping.
parameters: none
response: Speed as a float value in meters per second (m/s).
example:
wav:swe:spe?
affects: All Tunable Laser modules
command: [:SOURce[n]][:CHANnel[n]]:WAVelength:SWEep:STARt
syntax: [:SOURce[n]][:CHANnel[n]]:WAVelength:SWEep:STARt<wsp>
<start value>[PM|NM|UM|MM|M]
description: Sets the starting point of the sweep.
parameters: The wavelength at which the sweep starts as a float value.
If you specify no units in your command, meters are used as the default.
response: none
example:
wav:swe:star 1500nm
affects: All Tunable Laser modules
command: [:SOURce[n]][:CHANnel[n]]:WAVelength:SWEep:STARt?
syntax: [:SOURce[n]][:CHANnel[n]]:WAVelength:SWEep:STARt?
description: Returns the starting point of the sweep.
parameters: none
response: The wavelength at which the sweep starts as a float value in meters.
example:
wav:swe:star?
affects: All Tunable Laser modules
Introduction to Programming
Signal Generation – The SOURce Subsystem
→
+5.00000000E-008<END>
→
+1.50000000E-006<END>
118