HP 8163A Programming Manual page 123

command: :TRIGger[n][:CHANnel[n]]:INPut
syntax: :TRIGger[n][:CHANnel[n]]:INPut<wsp><trigger response>
description: Sets the incoming trigger response.
parameters: IGNore:
SMEasure:
CMEasure:
NEXTstep:
SWStart:
NOT E
response: none
example:
trig1:inp ign
Introduction to Programming
Triggering - The TRIGger Subsystem
Ignore incoming trigger.
Start a single measurement. If a measurement function
is active, see
":SENSe[n][:CHANnel[n]]:FUNCtion:STATe" on
page 83, one sample is performed and the result is
stored in the data array, see
":SENSe[n][:CHANnel[n]]:FUNCtion:RESult?" on
page 83.
Start a complete measurement. If a measurement
function is active, see
":SENSe[n][:CHANnel[n]]:FUNCtion:STATe" on
page 83, a complete measurement function is
performed.
Perform next step of a stepped sweep.
Start a sweep.
You must prearm a wavelength sweep or a measurement function
before an action can be triggered:
First, set the incoming trigger response.
Then:
prearm a wavelength sweep using
"[:SOURce[n]][:CHANnel[n]]:WAVelength:SWEep:[STATe]"
on page 119. The wavelength of the Tunable Laser module is set
to the start wavelength of the sweep.
or prearm a measurement function using
":SENSe[n][:CHANnel[n]]:FUNCtion:STATe" on page 83.
The module performs the appropriate action when it is triggered.
123