Lenovo ThinkSystem SR630 V3 User Manual page 97

About this task
Attention:
• Read "Installation Guidelines" on page 51
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
"Power off the server" on page
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding systems.
Procedure
Step 1. Touch the static-protective package that contains the backplane to any unpainted surface on the
outside of the server. And then, take the backplane out of the package and place it on a static-
protective surface.
Step 2. Connect the cables to the backplane. See
Step 3. Put the backplane down into place.
Figure 37. Installation of backplane for 16 EDSFF drives
a. Align the hole on the backplane with the pin on the chassis, place it down, and slightly slide
it as shown.
b. Tighten the screw to secure the backplane.
Step 4. Connect the cables to the system board assembly and the backplane. See
cable routing" on page
remove them before plugging in.
After you finish
1. Reinstall all the drives and drive cages into the drive bays. See
121.
2. Complete the parts replacement. See
and "Safety inspection checklist" on page 52
68.
Chapter 6 "Internal cable routing" on page
249. If the cable connectors come with protective dust caps, make sure to
"Complete the parts replacement" on page
Chapter 6 "Internal
"Install a hot-swap EDSFF drive" on page
246.
.
Chapter 5 Hardware replacement procedures
to ensure that you
249.
87