Lenovo ThinkSystem SR630 V3 User Manual page 162

• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding systems.
• Make sure to adopt one of the supported configurations listed in
order" on page 56.
• Memory modules are sensitive to static discharge and require special handling. Refer to the standard
guidelines at "Handling static-sensitive devices" on page
– Always wear an electrostatic-discharge strap when removing or installing memory modules.
Electrostatic-discharge gloves can also be used.
– Never hold two or more memory modules together so that they do not touch each other. Do not stack
memory modules directly on top of each other during storage.
– Never touch the gold memory module connector contacts or allow these contacts to touch the outside
of the memory module connector housing.
– Handle memory modules with care: never bend, twist, or drop a memory module.
– Do not use any metal tools (such as jigs or clamps) to handle the memory modules, because the rigid
metals may damage the memory modules.
– Do not insert memory modules while holding packages or passive components, which can cause
package cracks or detachment of passive components by the high insertion force.
Important: Remove or install memory modules for one processor at a time.
Firmware and driver download: You might need to update the firmware or driver after replacing a
component.
• Go to
https://datacentersupport.lenovo.com/products/servers/thinksystem/sr630v3/7d72/downloads/driver-
to see the latest firmware and driver updates for your server.
list/
• Go to "Update the firmware" on page 433
Procedure
Step 1. Power off the server and disconnect all power cords.
Step 2. Touch the static-protective package that contains the memory module to any unpainted surface on
the outside of the server. Then, take the memory module out of the package and place it on a
static-protective surface.
Step 3. Locate the required memory module slot on the processor board.
Note: Ensure that you observe the installation rules and sequence in
rules and order" on page
ThinkSystem SR630 V3 User Guide
152
for more information on firmware updating tools.
56.
"Memory module installation rules and
54:
"Memory module installation