Lenovo ThinkSystem SR630 V3 User Manual page 156

a. Loosen the six screws on the LACM module shipping tray.
b. Lift the LACM by the module handle (LACM heat sink bracket) to separate the module from
the shipping tray.
Step 3. Make sure you have an alcohol cleaning pad available.
Attention: If there is any old thermal grease on the processors, gently clean the top of the
processors with an alcohol cleaning pad.
Step 4. Install the processor to the LACM.
1. Align the triangular mark on the cold plate assembly label with the triangular mark on the
processor carrier and processor.
2. Install the LACM onto the processor-carrier.
3. Press the carrier into place until the clips at all four corners engage.
Note: If your server only has one processor installed, generally processor one, it is required to
install a cover to the empty socket of processor two before you proceed with further installation.
Figure 88. Install the processor socket cover
ThinkSystem SR630 V3 User Guide
146