Step 2.
Remove the system board assembly from the chassis.
Figure 196. System board assembly removal
a.
Hold the lift handle
assembly toward the front of the server.
b.
Lift the system board assembly out of the chassis.
Step 3.
Remove the Firmware and RoT Security module, see
Module" on page
Step 4.
Remove the system I/O board, see
Figure 197. The processor board
Note: The processor board comes with a supporting metal sheet. No further removal is needed.
After you finish
Important: Before you return the system board assembly, make sure that the processor socket is covered.
There is a processor external cap covering the processor socket on the new system board assembly. Slide
and lift the release pin
1
223.
"Remove the system I/O board" on page
at the same time and slide the system board
2
"Remove the Firmware and RoT Security
.
Chapter 5
Hardware replacement procedures
229.
235