Lenovo ThinkSystem SR630 V3 User Manual page 83

Do not place any object on top of a rack-mounted device unless that rack-mounted device is intended
for use as a shelf.
CAUTION:
• Potential stability hazards exist. The rack might tip over and cause serious personal injury.
• Before extending the rack to the installation position, read the
Do not put any load on the slide-rail mounted equipment in the installation position. Do not leave
the slide-rail mounted equipment in the installation position.
About this task
Attention:
• Read "Installation Guidelines" on page 51
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
"Power off the server" on page
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding systems.
CAUTION:
Make sure to have three people operate the server installation procedures to prevent injury.
Procedure
Step 1. From the front of the rack, pull the rails all the way out until they stop.
Attention: You can only install the server successfully when the rails are fully extended.
Rack front
Figure 25. Pulling out the rails
and "Safety inspection checklist" on page 52
68.
"Installation Guidelines" on page
.
Chapter 5 Hardware replacement procedures
51.
to ensure that you
73