Lenovo ThinkSystem SR630 V3 User Manual page 193

Anti-tilt wire bail
6
Processor carrier
7
Clips to secure carrier to heat sink
8
Torque screwdriver type list
Torx T30 head screwdriver
Procedure
Step 1. If you are replacing a processor and reusing the heat sink.
a. Remove the processor identification label from the heat sink and replace it with the new label
that comes with the replacement processor.
b. If there is any old thermal grease on the heat sink, wipe the thermal grease from the bottom of
the heat sink with an alcohol cleaning pad.
Step 2. If you are replacing a heat sink and reusing the processor.
a. Remove the processor identification label from the old heat sink and place it on the new heat
sink in the same location. The label is on the side of the heat sink closest to the triangular
alignment mark.
Note: If you are unable to remove the label and place it on the new heat sink, or if the label is
damaged during transfer, write the processor serial number from the processor identification
label on the new heat sink in the same location as the label would be placed using a permanent
marker.
b. Install processor in new carrier.
Figure 116. Installing a processor carrier
Note: Replacement heat sinks come with both gray and black processor carriers. Make sure
to use the carrier with the same color as the one you discarded earlier.
1. Make sure the handle on the carrier is in the closed position.
Processor contacts
14
Processor triangular mark
15
Screw Type
Torx T30 screw
.
Chapter 5 Hardware replacement procedures
183