Lenovo ThinkSystem SR630 V3 User Manual page 242

Step 1. Touch the static-protective package that contains the system I/O board to any unpainted surface
on the outside of the server. Then, take the system I/O board out of the package and place it on a
static-protective surface.
Step 2. Install the system I/O board.
Figure 194. System I/O board installation
a. Align the contacts on the system I/O board with the slots on the processor board, and use
both hands to push the system I/O board and slightly insert it into the connector.
Note: To prevent the contacts of the system I/O board from damage, ensure that the system I/
O board is aligned correctly with the connector on the processor board, and remains as
horizontal as possible during the insertion.
Figure 195. Install with both hands
b. Install the screws to install the system I/O board to the supporting metal sheet.
Step 3. Install the Firmware and RoT Security Module, see
on page 225.
Step 4. Install the MicroSD card, see
After you finish
ThinkSystem SR630 V3 User Guide
232
"Install the Firmware and RoT Security Module"
"Install the MicroSD card" on page 155.