Table of Contents
Advertisement
a.
Disconnect the cable of the intrusion switch from the processor board. For the location of
the intrusion switch connector and cable routing information, refer to
connectors" on page 36
clip.
b.
Insert the tip of a slotted screwdriver into the gap between the cage and switch and push
outwards.
c.
Slide the intrusion switch as shown to remove it.
Step 4.
Re-install the system fan 4.
a.
Align the four corners of the fan to fan module socket and put it down.
b.
Press the fan latch down to ensure that it is plugged in the connector.
After you finish
and
"Intrusion switch" on page
"System-board-assembly
263. Route the cable out of the cable
.
Chapter 5
Hardware replacement procedures
137
Advertisement
Chapters
Table of Contents
Troubleshooting
