Lenovo ThinkSystem SR630 V3 User Manual page 159

a. Install the liquid detection sensor module into the two clips on the holder. Ensure that the
module is secured in place.
b. After the module is secured, route the cable through the cable clips to keep tidy for later
cable routing arrangements.
Step 8. Remove the system fan 5 from the fan module.
Step 9. Connect the pump 1 cable of the LACM to the connector on the system board assembly. See
"Liquid assisted cooling module" on page
Step 10. Re-install the system fan 5 into the fan module.
a. Align the four corners of the fan to fan module socket and put it down.
b. Press the fan latch down to ensure that it is plugged in the connector.
After you finish
275.
.
Chapter 5 Hardware replacement procedures
149