Lenovo ThinkSystem SR630 V3 User Manual page 189

a. Fully loosen the Torx T30 nuts on the PHM in the removal sequence shown on the heat-sink
label.
b. Rotate the anti-tilt wire bails inward.
c. Carefully lift the PHM from the processor socket. If the PHM cannot be fully lifted out of the
socket, further loosen the Torx T30 nuts and try lifting the PHM again.
Notes:
• Do not touch the contacts on the bottom of the processor.
• Keep the processor socket clean from any object to prevent possible damages.
After you finish
• Each processor socket must always contain a cover or a PHM. Protect empty processor sockets with a
cover or install a new PHM.
• If you are not going to install a PHM back, cover the processor socket with the socket cover and install a
PHM filler.
– Open the retaining clip on each end of the memory module slots next to the left and right sides of
the processor two slot.
– Align the PHM filler with the slots, and place the filler on the slots with both hands. Firmly press the
filler straight down into the slots until the retaining clips snap into the locked position.
• If you are removing the PHM as part of a processor board replacement, set the PHM aside.
• If you are reusing the processor or heat sink, separate the processor from its retainer. See
processor from carrier and heat sink" on page
• If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Demo video
Watch the procedure on YouTube
180.
Chapter 5
"Separate the
.
Hardware replacement procedures
179