Figure 358. Cable routing for six SAS/SATA drives and two AnyBay drives and two NVMe front drive bays with a 16i CFF
HBA/RAID adapter (Gen 3 or Gen 4)
Table 165. Mapping between one front SAS/SATA backplane and a CFF RAID adapter
Backplane/adapter
Front BP (SAS)
CFF RAID adapter
Front BP (power)
Front BP (NVMe)
10 x 2.5'' AnyBay (Gen 5)
See this section to understand the cable routing of 10 front AnyBay drives with 10 x 2.5'' backplane (Gen 5)
installed.
To connect cables for a 7mm drive backplane, refer to
To connect cables for M.2 drives, refer to
To connect cables for rear NVMe drives, refer to
backplane (Gen 5) installed" on page
From
SAS 0–3
1
SAS 4–7
2
MB input
3
Power and sideband
4
NVMe 6–7
5
NVMe 8–9
6
"7mm drive backplane" on page
"M.2 drive backplane" on page
"Rear NVMe backplane cable routing with 10 x 2.5'' AnyBay
273.
To
C0
1
C1
2
PCIe 3
3
Power port for front BP
4
PCIe 2
5
PCIe 1
6
270.
267.
.
Chapter 6
Internal cable routing
423