Lenovo ThinkSystem SR630 V3 User Manual page 241

Figure 193. System I/O board removal
a. Remove the screws that secure the system I/O board.
b. Lift and hold the plunger and slide the system I/O board towards the rear to disengage it
from the processor board.
After you finish
Important:
• Before you return the processor board, make sure that you install the processor socket covers to the new
processor board.
• If replacing a new system I/O board, transfer the MicroSD card from the old system I/O board to the new
one. See "Remove the MicroSD card" on page 154
• If you are planning to recycle the system board assembly, follow the instructions in
disassembling for recycle" on page 483
Install the system I/O board
Follow the instructions in this section to install the system I/O board.
About this task
Attention:
• Read "Installation Guidelines" on page 51
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
"Power off the server" on page
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding systems.
Watch the procedure
A video of this procedure is available on YouTube:
CfNsWy-689CRZHExrZEi9I
Procedure
for compliance with local regulations.
and "Safety inspection checklist" on page 52
68.
.
and "Install the MicroSD card" on page
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
.
Chapter 5 Hardware replacement procedures
155.
Appendix A "Hardware
to ensure that you
231