Step 4.
Install the system board assembly to the server.
Figure 199. System board assembly installation
a.
Hold the lift handle
assembly into the chassis.
b.
Slide the system board assembly to the rear of the server until the system board assembly
snaps into position. Ensure that:
• The rear connectors on the new system board assembly are inserted into the corresponding
holes in the rear panel.
• The release pin
After you finish
1. Install any components that you have removed from the failing system board assembly.
•
"Processor and heat sink" on page 176
•
"Memory modules" on page 150
•
"System fans" on page 239
•
"RAID flash power modules" on page 189
•
"Riser assemblies" on page 204
•
"CMOS battery" on page 94
•
"OCP module" on page 166
and the release pin
1
2
secures the system board assembly in place.
2
at the same time to lower the system board
.
Chapter 5
Hardware replacement procedures
237