Figure 73. Remove a drive filler
Step 3.
Install the drive in the drive bay.
Figure 74. Hot-swap drive installation
a.
Ensure that the drive tray handle is in the open position. Slide the drive into the drive bay
until it snaps into position.
b.
Close the drive tray handle to lock the drive in place.
Step 4.
Check the drive LEDs to verify that the drive is operating normally. For details, see
page
455.
Step 5.
Continue to install additional hot-swap drives if necessary.
After you finish
1. Reinstall the security bezel if you removed it. See
ThinkSystem SR630 V3 User Guide
118
"Install the security bezel" on page
"Drive LEDs" on
215.