AGFA Drystar 4500 Reference Manual page 90

D 4500 R
RYSTAR EFERENCE MANUAL
On the 'Image quality' screen, press the Down key, followed by the Confirm key
6
to select 'Interpolation'.
The 'Interpolation' screen is displayed:
<Modality name>
1*CubicBell
2 Cubic Hi-Res
3 Linear
4 Replication
5 None
The current interpolation setting for the selected modality is marked with an *.
Press the Up/Down key to select the desired Interpolation setting for this
7
modality.
# If you select "Cubic Hi-Res" the following screen will appear, allowing you to
adjust the smoothing factor:
<Modality name>
# If you select "Cubic Bell" the following screen will appear, allowing you to
adjust the smoothing factor:
<Modality name>
Press the Confirm key to store the data, or the Escape key to quit the procedure
8
without any changes.
The user should be aware that the interpolation values differ when the
A#Sharp feature is deactivated. The A#Sharp feature, which is a
technology that enhances the image sharpness, is active by default. For
more information about (de)activating the A#Sharp feature, refer to the
Drystar 4500 Service manual.
90
Advanced operation (key-operator mode)
Default 0.70
Default 0.90
2800E EN 20050215