AGFA Drystar 4500 Reference Manual page 57

Image quality
'Changing general image quality settings - Film calibration'
'Changing general image quality settings - Default densitometer'
'Changing Image quality setting for a modality - Selecting a lookup table'
'Changing Image quality setting for a modality - Changing the
Interpolation'
'Changing Image quality setting for a modality - Changing the maximum
density (Dmax)'
Accessing the Change settings menu
Before you can change the settings, the 'printer installation wizard' should be
executed. If the printer has not been installed yet, the following screen is displayed:
Proceed as follows to access the 'Change settings' menu:
Press the Key-operator key to enter the key-operator mode.
1
On the Key-operator main menu, press the Down key once, followed by the
2
Confirm key to select 'Change settings'.
The 'Change settings' screen is displayed:
This menu is the starting point for changing the settings (see below).
2800E EN 20050215
D 4500 R
RYSTAR EFERENCE MANUAL
84
86
87
89
91
Advanced operation (key-operator mode)
57