AGFA Drystar 4500 Reference Manual page 110

D 4500 R
RYSTAR EFERENCE MANUAL
Locate and check on sight the print head resistor line.
5
Be careful not to touch the print head resistor line.
Clean the print head resistor line.
6
Gently pass over the resistor line a few times with a lint free cloth slightly moistened
with Isopropyl alcohol or Ethanol. Do this in only one direction, i.e. from left to
right, without lifting the cloth.
Do not apply any pressure on the print head because this pressure may cause
damage on the interconnections underneath the print head.
Close the front cover.
7
After you have cleaned the print head resistor line and closed the door, the
8
printer will continue.
110
Advanced operation (key-operator mode) 2800E EN 20050215