AGFA Drystar 4500 Reference Manual page 88

D 4500 R
RYSTAR EFERENCE MANUAL
Press the Confirm key to select 'Look-up table'.
6
The 'Lookup table' screen is displayed:
<Modality name>
1 Kanamori
2 Linear
3 Kanamor-like (100)
Press the Up/Down key to select the desired lookup table.
7
Press the Confirm key to store the data, or the Escape key to quit the procedure
8
without any changes.
# In case Kanamori-like is selected, change the Kanamori-value.
An additional screen for the Kanamori-like value is displayed:
<Modality name>
All Kanamori-like curves are selectable starting from 75 until 220 in steps of 1 unit.
In case a number of settings for a modality were set via a remote computer, you will
not be able to change the image quality information for this modality manually. If
this is the case, the following screen will appear:
<Modality name>
In case the image quality parameters need to be changed for this modality, please
use the DICOM Configuration tool, in the specialist mode on the remote PC. You
can also delete this modality (refer to
create a new modality with the same name. For this new modality new parameters
can be assigned via the local keypad.
88
Advanced operation (key-operator mode)
100
'Removing a modality' on page 80) and
2800E EN 20050215