Mercedes-Benz EQS 2021 Owner's Manual page 220

Remove socket cover 4 from the lower con‐
#
nection of vehicle socket 3.
% The CCS charging cable connector requires
both vehicle socket connections 3.
Insert the charging cable connector into vehi‐
#
cle socket 3 to the stop.
Make sure that the charging cable is not taut
when inserted.
Status display 2 flashes orange and, as
soon as the high-voltage battery is charged,
blue.
% When the charging sequence for the ambient
lighting is activated, the ambient lighting
lights up for approximately 30 seconds as
with status display 2 (
/
If the charging cable is connected to the vehicle,
the drive system cannot be started and the vehi‐
cle cannot be moved.
At the start of the charging process, the charge
level display is shown in the driver's display with
a charging prediction. The charging prediction
refers to the time at which the high-voltage bat‐
tery will be fully charged.
% When the vehicle is switched on, a lightning
symbol appears next to the charge level dis‐
play in the driver's display during the charg‐
ing process.
% Depending on the temperature, the fan and
battery cooling system may audibly switch
on during the charging process.
% If the vehicle is idle for lengthy periods and
connected to the mains supply, the high-volt‐
age battery will be recharged automatically
as needed or when electrical consumers are
activated (e.g. the pre-entry climate control).
Ending the direct current charging process
(mode 4)
page 163).
Requirements:
The distance between the key and the vehicle
R
does not exceed 1 m.
Driving and parking 217
Combo 1 vehicle socket
Press charging interruption button 2.
#
The charging process is ended. Status dis‐
play 1 lights up white. The vehicle socket is
unlocked.
Press and hold button 3 on the charging
#
cable connector and remove the charging
cable connector from the vehicle socket.