Mercedes-Benz EQS 2021 Owner's Manual page 216

Hide thumbs Also See for EQS 2021:
Table of Contents

Advertisement

Combo 2 vehicle socket
Press the rear centre of socket flap
#
fold open the socket flap.
Status display
2
lights up white.
%
When the vehicle is started (the õ display
is lit in the driver's display), socket flap
cannot be opened.
%
Only upper connection
charging cable connector.
To charge at a mains socket, insert the mains
#
plug into the mains socket of the external
power source as far as it will go.
Insert the charging cable connector into vehi‐
#
cle socket connection
wallbox/charging station is not equipped
with a charging cable, insert the plug of the
vehicle's charging cable into the wallbox/
charging station socket to the stop.
Make sure that the charging cable is not taut
when inserted.
Status display
soon as the high-voltage battery is charged,
blue.
%
When the charging sequence for the ambient
1
and
lighting is activated, the ambient lighting
lights up for approximately 30 seconds as
with status display
If the charging cable is connected to the vehicle,
1
the drive system cannot be started and the vehi‐
cle cannot be moved.
3
is required for the
3
to the stop. If the
2
flashes orange and, as
2
(
page 163).
/
Driving and parking 213
At the start of the charging process, the charge
level display is shown in the driver's display with
a charging prediction. The charging prediction
refers to the time at which the high-voltage bat‐
tery will be fully charged.
%
When the vehicle is switched on, a lightning
symbol appears next to the charge level dis‐
play in the driver's display during the charg‐
ing process.
%
Depending on the temperature, the fan and
battery cooling system may audibly switch
on during the charging process.
%
If the vehicle is idle for lengthy periods and
connected to the mains supply, the high-volt‐
age battery will be recharged automatically
as needed or when electrical consumers are
activated (e.g. the pre-entry climate control).
Ending the alternating current charging proc‐
ess (mode 2/3)
Requirements:
The distance between the key and the vehicle
R
does not exceed 1 m.

Advertisement

Table of Contents
loading

Table of Contents