Install A Dual Rack-Mount Kit - Fluke BT5300 Series User Manual

2. Attach the other rack bracket (②) to the left-front side of the Product with three #8-32 x ½ inch
panhead screws (①).
3. With three M6 panhead hex screws (⑤), and three nuts, fasten the right-side of Rack Faceplate
(③) to the left side of rackmount.
4. Install the entire assembly into the rack. From the rear of the rack, align the assembly to the holes
in the rack. At the front of the rack, use six M6 panhead hex screws (⑤) and six nuts to fasten the
Rack Faceplate (③) and Rack Screw Plate (④) through the rack and Rack Brackets (②).
1
3
5

Install a Dual Rack-Mount Kit

To Install a Dual Rack-Mount Kit:
1. Place both Products side-by-side on a flat surface and use three #8-32 x ½-inch panhead screws
(①) to install the Rack Bracket (②) to the outer left and right sides of the Product. Refer to step 1
under Install a Single Rack-Mount Kit.
2. Attach the Inner Rack Bracket (⑥) to the inner right and left sides of both Products with six #8-32
x ½-inch panhead screws (①).
3. Attach the Inner Rack Bracket (⑥) to the inner right and left sides of both Products with six #8-32
x ½-inch panhead screws (①). And insert the two guide pins into the two holes in both sides of the
Inner Rack Bracket (⑥).
4. Align the front tabs of the Inner Rack Brackets (⑥) and fasten the Small Rack Screw Plate (⑦) to
the front tabs with two #8-32 x ½-inch panhead screws (①).
Figure 63. Single rack-mount kit
Battery Tester
Appendix
2
1
4
153