Fluke BT5300 Series User Manual page 122

BT5300 Series
User Manual
STATus:OPERation?
FETCh?
3. Enable continuous initiation, FETCh one measurement
SWITch:MODule DISable
TRIGger:SOURce EXTernal
INITiate:CONTinuous ON
*TRG
STATus:OPERation?
FETCh?
Module Internal, Single Channel, Internal Trigger
In this scenario, it is desired to measure the resistance and/or voltage from the internal switch channel
under internal triggering. Below are three methods that can be used.
1. Disable continuous initiation, READ one measurement
SWITch:MODule INTernal
TRIGger:SOURce IMMediate
ROUTe:CLOSe (@102)
INITiate:CONTinuous OFF
READ?
READ?
2. Disable continuous initiation, FETCh one measurement
SWITch:MODule INTernal
TRIGger:SOURce IMMediate
ROUTe:CLOSe (@102)
INITiate:CONTinuous OFF
110
Command
Command
Command
Command
Query the Operation Status register until the Bit 11 (Measure
Done) is set.
Return the latest reading (voltage and/or resistance).
Configure the instrument to measure the signal from the front
panel input post without using internal/external switch channels.
Configure the trigger source to be external.
Enable continuous measurement.
Trigger one measurement (Trigger Key signal can achieve the
same result).
Query the Operation Status register until the Bit 11 (Measure
Done) is set.
Return the latest reading (voltage and/or resistance).
Configure the instrument to use the internal switch channel as
measurement input channel.
Configure the trigger source to be internal.
Configure channel 102 to be measurement input channel.
Disable continuous measurement.
Acquire one measurement then return the reading (voltage and
resistance).
Acquire another measurement then return the reading (voltage
and/or resistance).
Configure the instrument to use the internal switch channel as
measurement input channel.
Configure the trigger source to be internal.
Configure channel 102 to be measurement input channel.
Disable continuous measurement.
Action
Action
Action
Action