Fluke BT5300 Series User Manual page 126

BT5300 Series
User Manual
2. Disable continuous initiation, FETCh one measurement
SWITch:MODule EXTernal
TRIGger:SOURce EXTernal
ROUTe:CLOSe (@102)
INITiate:CONTinuous OFF
INITiate
*TRG
STATus:OPERation?
FETCh?
3. Enable continuous initiation, FETCh one measurement
SWITch:MODule EXTernal
TRIGger:SOURce EXTernal
ROUTe:CLOSe (@102)
INITiate:CONTinuous ON
*TRG
STATus:OPERation?
FETCh?
Module Internal, One-Shot Scan, Internal Trigger
In this scenario it is desired to scan and measure several internal switch channels in a one-shot
fashion under internal triggering.
*RST
*CLS
TRIGger:SOURce IMMediate
SWITch:MODule INTernal
SWIT:MOD:STAT? INT
ROUTe:SCAN (@101:132)
114
Command
Command
Command
Configure the instrument to use the external switch channel as
measurement input channel.
Configure the trigger source to be external.
Configure channel 102 to be measurement input channel.
Disable continuous measurement.
Initiate the instrument to Trigger Wait State.
Trigger one measurement (Trigger key signal can achieve the
same result).
Query the Operation Statues register until the Bit 11 (Measure
Done) is set.
Return the latest reading (voltage and/or resistance).
Configure the instrument to use the external switch channel as
measurement input channel.
Configure the trigger source to be external.
Configure channel 102 to be measurement input channel.
Enable continuous measurement.
Query the Operation Status register until the Bit 11 (Measure
Done) is set.
Query the operation status until bit 11 (measure done).
Return the latest reading (voltage and/or resistance).
Reset the instrument to the power-on state.
Clear the Status Byte Register and all event registers, and clear
the Error Queue.
Configure the trigger source to be internal.
Configure the instrument to use the internal switch channel as
measurement input channel.
Query the internal switch module's slots state.
According to the active slots' state, configure scan channel list
from 101 to 132.
Action
Action
Action