Table of Contents
Advertisement
Do not use the Product around explosive gas, vapor, or in damp or wet
environments.
Do not use the Product if it operates incorrectly.
Disable the Product if it is damaged.
Do not use the Product if it is altered or damaged.
Use only the mains power cord and connector approved for the voltage and
plug configuration in your country and rated for the Product.
Replace the mains power cord if the insulation is damaged or if the
insulation shows signs of wear.
Disconnect the mains power cord before you remove the Product covers.
Make sure the ground conductor in the mains power cord is connected to a
protective earth ground. Disruption of the protective earth could put voltage
on the chassis that could cause death.
Do not put the Product where access to the mains power cord is blocked.
Measure a known voltage first to make sure that the Product operates
correctly.
Use the correct terminals, function, and range for measurements.
Use only cables with correct voltage ratings.
Do not use test leads if they are damaged. Examine the test leads for
damaged insulation and measure a known voltage.
Do not make connections on hazardous live conductors in damp or wet
environments.
Do not operate the Product with covers removed or the case open.
Hazardous voltage exposure is possible.
Keep fingers behind the finger guards on the probes.
Do not apply more than the rated voltage, between the terminals or between
each terminal and earth ground.
Do not touch voltages >30 V ac rms, 42 V ac peak, or 60 V dc.
Use only specified replacement fuses.
Have an approved technician repair the Product.
Use this Product indoors only.
Battery Tester
Introduction
3
Advertisement
Table of Contents
