Omron SYSMAC CS1W-CLK13 Operation Manual page 133

Setting Data Links
N: DM 30000 + 100 Controller Link Unit number
15 14 13 12 11 10 9
- -
Word N
0: Always specify 0.
-: Other settings
Automatic Setting, Equality Layout
15
Area 1 data link start word (BCD) *1
N+1
N+2 Area 1 type
Number of send words per node of Area 1 (BCD)
N+3
N+4 Rightmost 4 digits of data link start word of Area 2 (DM area) (BCD)
N+5 Area 2 type
N+6 Number of send words per node of Area 2 (BCD)
N+7 First data link status word (BCD)
15 14 13 12 11 10 9
N+8
16 15 14 13 12 11 10 9
N+9
32 31 30 29 28 27 26 25 24 23 22 21 20 19 18 17
N+10
48 47 46 45 44 43 42 41 40 39 38 37 36 35 34 33
N+11
- - 62 61 60 59 58 57 56 55 54 53 52 51 50 49
-: Not used.
*1: BCD: Set the value as binary-coded decimal.
*2: With Optical Bus (CLK11) Optical Link Units, N+10 and N+11 (node addresses 33 to 62) cannot be used.
Settings
110
Lot number notation: The first two digits refer to the year (last two
2. Controller Link Units and Support Boards other than those listed above
cannot participate in 1:N allocation data links. They can, however, join the
network if the parameter for specifying data link participation status in the
DM parameters area is set so that they do not participate in the data links.
3. For automatic data link creation with 1:N allocations, use the CX-Net in CX
Programmer version 3.2 or later.
Set the following DM parameter area settings in the PLC that is the startup
node.
8 7 6
- - -
0 0 0 0 0
8 7
00
Leftmost digit of data link start word of
Area 2 (BCD)
8 7 6 5 4
8 7 6 5
Item
Data link mode
Area 1 data link start
word
digits of years from 2000 onwards), and the
following two digits indicate the month (01 to
12, for January to December, respectively).
(The last 7 digits are not relevant.)
5 4 3 2 1 0
0 0 0 -
Data link mode
000: Manual setting
001: Automatic setting (equality layout)
101: Automatic setting (1:N allocations)
0
3 2 1 0
4 3 2 1
Nodes to participate in the data links (*2)
The numbers indicate node numbers.
The value assigned indicates whether the
node is to participate in the data links.
Participate: 1
Not participate: 0
Specify automatic (01).
Set the word address in BCD.
CIO Area: CIO 000 to CIO 6143
LR Area: LR 00 to 199 (*)
*: When a word between LR 000 and LR 199 is
specified, the data link area will be allocated
between CIO 1000 and CIO 1199.
Section 5-2
Setting range